Enerdrive ePRO EPBC-1290, Руководство пользователя

Страница: 12 / 32

Model Cable size
(*length ≤ 3 m)
Cable size
(*length = 3 to 6m)
Battery fuse
(quick type)
EPBC-1290 35mm2 (AWG2) 50mm2 (AWG0) 100-120Amp
EPBC-2450 25mm2 (AWG3) 35mm2 (AWG2) 60-80Amp
EPBC-2480 35mm2 (AWG2) 50mm2 (AWG0) 100-120Amp
* Note: Cable size length is a total of both the Positive and Negative cable run.
2
The AC input must be protected by an earth leakage circuit breaker with over-current
protection (RCBO), that can withstand the maximum nominal current consumption
from the charger without tripping. All AC wiring must be sized accordingly. Please
consult the following table to determine the correct AC wiring and RCBO sizes:
Model AC wiring size / RCBO size
(220-240VAC)
AC wiring size / RCBO size
(100-120VAC)
EPBC-1290 1.5mm2 (AWG15) / 8A (30mA) 2.5mm2 (AWG13) / 16A (30mA)
EPBC-2450 1.5mm2 (AWG15) / 10A (30mA) 4mm2 (AWG11) / 20A (30mA)
EPBC-2480 2.5mm2 (AWG13) / 16A (30mA) -
Please make sure that the information in this table is in accordance to all locally applicable
electrical regulations.
3
Up to 3 battery banks can be connected to the charger. Each output can supply the
full rated charging current. The total charging current of all 3 outputs combined, will
never exceed the maximum rated charging current. All 3 outputs are isolated from
each other by highly efficient active rectifiers.
WARNING
The schematic (left) shows a typical standalone installation. No guarantees are given on
the compliance of any local electrical regulations. Please make sure that the complete
installation is made in accordance to all locally applicable electrical regulations.
WARNING
This Class I product must be earthed! Always connect the PE wire or chassis ground
screw at the bottom of the enclosure to your central ground (vehicle chassis, grounding
system of your boat etc.)
Enerdrive ePRO Battery Charger Owners Manual (Rev. 1.0) Page 12