INSTALLATION INSTRUCTIONS
CAUTION:
A potential electrical shock hazard exists even
when AC power supply has been turned off.
Disconnect Battery connector before servicing
fixture. Do not remove the wire harness con-
nector when AC power is present.
APPROXIMATE WORKING VOLTAGE
Battery Pack input: 120 OR 277V AC
IMPORTANT SAFEGUARDS
WARNING: FAILURE TO FOLLOW THESE INSTRUCTIONS AND WARNINGS MAY RESULT IN DEATH, SERIOUS INJURY
OR SIGNIFICANT PROPERTY DAMAGE –
For your protection, read and follow these warnings and instructions carefully before installing or maintaining this equip-
ment. These instructions do not attempt to cover all installation and maintenance situations. If you do not understand
these instructions or additional information is required, contact Lithonia Lighting or your local Lithonia Lighting distributor.
WARNING: RISK OF ELECTRIC SHOCK – NEVER CONNECT TO, DISCONNECT FROM OR SERVICE WHILE EQUIP-
MENT IS ENERGIZED.
WARNING: RISK OF FIRE – Lamps are hot. Keep combustibles material away from hot parts. Observe lamp
manufacturer’s warnings, recommendations and restrictions on lamp operation and maintenance. Make sure lamps are
correctly installed.
WARNING: DO NOT USE ABRASIVE MATERIALS, OR OTHER SOLVENTS. USE OF THESE SUBSTANCES MAY DAMAGE
FIXTURE, WHICH MAY RESULT IN PERSONAL INJURY.
WARNING: RISK OF PERSONAL INJURY – This product may have sharp edges. Wear gloves to prevent cuts or abrasions
when removing from carton, handling, installing and maintaining this product. (WHERE APPLICABLE)
•
Before wiring to power supply, turn off electricity at fuse or circuit breaker.
•
Disconnect A.C. power and unplug battery before servicing.
•
Consult your local building code for approved wiring and installation.
•
Do not use outdoors.
•
Do not let power supply cord touch hot surfaces.
•
Do not mount near gas or electric heater.
•
Do not install a damaged fixture.
•
This product must be installed in accordance with the applicable installation codes and ordinances.
•
Proper grounding is required to ensure personal safety. (WHERE APPLICABLE)
•
All service shall be performed by qualified service personnel. This product must be installed and maintained in accor-
dance with the applicable installation codes by a person familiar with the construction and operation of the product and
the hazards involved.
•
Equipment should be mounted in locations and at heights where it will not readily be subjected to tampering by unautho-
rized personnel.
•
The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
•
Do not use this equipment for other than intended use.
SAVE THESE INSTRUCTIONS
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
FIELD INSTALLABLE FLUORESCENT BATTERY
PACK IS UNIVERSALLY COMPATIBLE WITH THE
BALLASTS AND OPERATING LAMP(S) IN THE
LAMP COMPATIBILITY TABLE (PAGE 3).
IMPORTANT NOTES:
Make sure that branch circuit feeds are derived from
a common phase for both normal lighting ballast and
Battery Pack prior to installation.
Notice: To ensure proper grounding, mount unit only
with metal cutting screws (not provided).
The Battery Pack can be used with a switched or
unswitched (night) circuit. When used with a switched
fixture it is important to note that the power to the
Battery Pack must be provided by an unswitched
circuit.
EMERGENCY FLUORESCENT BATTERYPACK
Model EI500
Содержание EI500
Страница 8: ...Page 8 ...
