Enerdrive DOMETIC EN312100, Руководство пользователя

Страница: 20 / 44

Page 20 Enerdrive Battery Charger Owners Manual Rev. 5.4
Remove the DC compartment cover by removing the two screws located on the top surface of the
unit near the AC wiring compartment.
Keep the connection between the battery and the charger as short as possible.
Connect one end of the positive wire (red wire) to the Bank one of charger positive terminal with
torque 4.0 ~ 5.0 N-m and the other end to the over current protection device, then the DC
disconnect device. Do not over tighten as this may result in damage to the charger.
Connect another wire from the DC disconnect device to the battery bank.
For systems with multi-battery banks: Follow the same instruction as on Bank 1 and connect to
Bank 2 & 3 accordingly.
Prepare the negative wire (black wire) and connect to the negative terminal of the charger.
Connect the other end of the negative wire to the negative terminal of the battery bank(s) or
the load side of a battery monitor shunt if installed.
Place the DC Compartment cover back to the original position and secure the cover using the two
screws provided.
To install the optional Remote Display in a specific location, a 6 pin standard RJ12 cable
(length of 7.5 meters supplied with Remote) is required.
Install the standard RJ12 cable in your desired location.
Connect one end of the RJ12 cable to the Interface Port and the other end of the cable to the
Display Panel.
The Remote Display is now ready for use.
Battery Temperature Sensor Connection
Optional Remote Display Connection
•
•
•
•
•
•
•
•
•
•
•
•
To install the temperature sensor, simply connect the RJ12 plug from the sensor to the RJ12 Temperature
Sensor Port located near the Interface Port. On the temperature sensor end, simply connect the ring
terminals to the negative terminal of the main battery bank.