The indication shown in figure 21.2 is viewed for 2s before entering in the
programming phase for the number of pulses per revolution (PPr). This value can be
set from 1 to 9999 ppr. After 2s or by a press
ENTER
, the numerical value appears on
the display with the first digit in flash. To modify this value, press
to increment
the flashing digit until it takes desired value and press
to pass to the next digit
to be modified. Repeat these operations until desired value is completed on the
display and press
ENTER
to go to the next programming phase.
From the Pro stage (see fig. 15.1), press
ENTER
to get access to the different
configuration modules (InP = input, dSP = display, and, if option installed, SEt =
setpoints). Select the display module by a press of
(the indication given in
figure 21.1 appears on the display).
Press
ENTER
to enter this module.
This manual describes the models µDIGI2-TAC instrument is
small format.
In this manual model is referred with the generic name of
µD-TAC.
Models µD-TAC are fully configurable by software to measure
rpm or rate in the desired units. The input stage admits direct
connection of several sensor types which are selected by a
DIP-switch.
The basic instrument is a soldered assembly composed of the
main board, and the display and keyboard module.
Optionally, it can be equipped with a 2-relay control output
card (2RE). This option provides an output connector at the
rear of the meter, status LED’s visible from the front and
specific programming routines which are enabled automatically
once the card is installed.
The outputs are isolated from signal input and power supply.
1. MODEL µDIGI2-TAC
3
19
[21.2] Pulses per revolution
UP
SHIFT
DATA
ENTER
1
2
[21.1] Display module
UP
SHIFT
DATA
ENTER
1
2
TACHOMETER CONFIGURATION (RPM)
This instrument conforms the following community standards: 89/336/CEE and 73/23/CEE
WARNING: Refer to the instructions manual to preserve safety protections.
