The display presents the previously selected input type : tAC = tachometer for RPM or
rAtE = rate meter.
To change this parameter, press
to switch to the desired option and press
ENTER
to save the choice in the memory and automatically return to the run mode
(indication Stor).
[15.3] Input type
UP
SHIFT
DATA
ENTER
1
2
Connect the instrument to the main supply, it automatically enters in a self-test
routine which briefly illuminates all segments and LED’s then shows the software
version and finally goes to the normal reading ("RUN" mode).
Press
ENTER
to acceed the programming mode.
The display shows the indication given in fig. 15.1. The LED’s 1 and 2 will flash during
the programming mode (except when programming the setpoints).
Press
ENTER
to have access to the programming parameters.
[15.1] Programming mode
UP
SHIFT
DATA
ENTER
1
2
Press
ENTER
to get access to the input configuration module (fig. 15.2).
Other modules (dSP = display, and, if option installed, SEt = setpoints) are selected
by pressing the
key.
[15.2] Input Module
UP
SHIFT
DATA
ENTER
1
2
2.5 - INPUT CONFIGURATION
ACCESS TO THE PROGRAMMING MODE
13
