The first menu parameter allows selection between two display modes.
The direct mode must be selected when the display readout and the input frequency
are to be in a direct proportion, that is, the display goes high as the frequency grows.
The reverse mode should be selected when reading variables that are inversely
proportional to the input frequency.
Press
to change the previously selected option if desired (dir = direct mode,
inv = reverse mode) and press
ENTER
to validate the choice and advance to the next
programming phase.
The indication shown in figure 18.3 is viewed for 2s before passing to the input
frequency programming phase. After 2s or by a press of
ENTER
, the display shows any
numerical value (depending on previous setting) with the first digit in flash.
If desired to modify this value, press
to vary the flashing digit from 0 to 9, and
the
key to advance to the next digit to be modified. Repeat these operations
until the display reads the required value and press
ENTER
to save the entry in the
memory; the decimal point goes in flash. Press repeatedly the
key to move the
decimal point to the desired position if required.
Press
ENTER
to save changes and go to the next programming phase.
From the Pro stage (see fig. 15.1), press
ENTER
to get access to the different
configuration modules (InP = input, dSP = display, and, if option installed, SEt =
setpoints). Select the display module by a press of
(the indication given in
figure 18.1 appears on the display).
Press
ENTER
to enter this module.
16
[18.2] Display mode
UP
SHIFT
DATA
ENTER
1
2
[18.3] Input frequency
UP
SHIFT
DATA
ENTER
1
2
RATE METER PROGRAMMING INSTRUCTIONS
[18.1] Display module
UP
SHIFT
DATA
ENTER
1
2
