Enerblue PURPLE, Руководство пользователя и по обслуживанию

Страница: 4 / 40

WARNING!
PAY VERY ATTENTION TO THE FOLLOWING INSTRUCTIONS
Enerblue declines every responsibility for eventual damages that
can directly or indirectly derive to persons or things in consequence
to the lacked observance the present instructions.
Any assembly/disassembly carried out by the USER that is not
contemplated in this manual or authorised by Enerblue, will be
considered as tampering, thereby jeopardising the safety functions
and invalidating the warranty and conformity of the unit.
The correct use of this Chiller depends on how you apply the instructions mentioned on this MANUAL�
You need to respect the following rules in order to keep the validity of the warranty:
> The tolerance for the power supply voltage must not be different than +/- 5% of the nominal power
supply voltage specified on the unit label; the phases imbalance must be lower than 2%;
> The water filter is mandatory;
> It is mandatory to respect the clearances specified on the dimensional drawings;
> It is mandatory to respect the working limits of the units specified in the user manual;
> It is mandatory to make regular maintenance activities on the unit as specified in the user manual�
The unit must always be placed vertically, the same rule is valid for transport and installation.
During the transport, the units must be supported by their base module (please verify the labels of
instructions for the correct lifting points)�
The technical data, information and illustrations contained in this manual were believed to
be correct at the time of print. Enerblue reserve the right to change specifications and other
information contained in this manual as part of our continual improvement process.
No liability can be accepted for any inaccuracies or omissions in this manual.
IF THE MENTIONED ABOVE RULES WILL NOT BE RESPECTED,
THE WARRANTY VALIDITY WILL BE STOPPED.
The power supply voltage must be connected because it is a protection
for the inverter compressor, this needs to avoid bad working mainly
when the outside temperature is lower than 5°C.
The units with inverter compressor must always be connected to the
power supply voltage, please don’t disconnect the power supply, NEVER!
Please check the line of the electrical power supply voltage and all
conditions of the plant before each START-UP of the unit with inverter
compressor.
THESE UNIT MUST BE
INSTALLED OUTDOOR