8
9
1. Safety instructions
• Read these safety instructions and the operation manual first before you install and commission the camera.
• Keep the manual in a safe place for later reference.
• Protect your camera from contamination with water and humidity to prevent it from permanent damage. Never switch the camera on when it gets wet.
Have it checked at an authorized service center in this case.
• Do not operate the cameras beyond their specified temperature, humidity or power ratings.
• Operate the camera only at a temperature range of -10°C to +50°C and at a humidity of max. 90%.
• To disconnect the power cord of the unit, pull it out by the plug. Never pull the cord itself.
• Pay attention when laying the connection cable and observe that the cable is not subject to heavy loads, kinks, or damage and no moisture can get in.
Do not attempt to disassemble the camera board from the dome.
• The warranty becomes void if repairs are undertaken by unauthorized persons.
• Use a dry cloth to clean the dome surface. In case the dirt is hard to remove, use a mild detergent and wipe gently.
Note: This is a class A digital device. This digital device can cause harmful interference in a residential area; in this case the user may be required
to take appropriate corrective action at his/her own expense.
2. General description
Indoor housing for Fastrax Series wall and ceiling mounted cameras
Standard version with fan
• Housing with tinted bubble: 6.8" (172mm), EDP No. 74075
• Housing with clear bubble: 6.8" (172mm), EDP No. 74077
• Protection class: IP65
Accessories pack: 3x dowel
3x screws with O-type sealing rings
1x Allen key 2mm for grub screw
3x screws M4x8
3x screws, tapping 4mm with O-type sealing ring
1x headless screw M4x4 for securing the housing to the pipe
1x Teflon tape
Outdoor housing for cameras of the Fastrax series for wall and ceiling mounting
• Standard version with heater, fan and sunshield
• Housing with tinted bubble: 6.8” (172mm), EDP No. 74078
• Housing with clear bubble: 6.8” (172mm), EDP No. 74076
• Protection class: IP65
Accessories pack: 3x dowel
3x screws with O-type sealing rings
1x Allen key 5mm for sun shield
1x Allen key 2mm for grub screw
3x screws M4x8
3x screws, self tapping 4mm with O-type sealing ring
1x grub screw M4x4 for securing the housing to the tube
1x Teflon tape
1x silicone (for sealing between mounting surface and mounting plate on the housing)
Dome housing for mounting of dome cameras in suspended ceilings, EDP No. 74057
• For in-ceiling installation of dome cameras of the Fastrax series
• Tinted bubble: 4.9” (125mm)
Accessories pack: 1x safety ring string (wire)
5x screws, self-tapping (M4, 12mm long)
1x screw, self-tapping (M4, 12mm long)
