EndRun Sonoma N12, Руководство пользователя

Страница: 24 / 174

S o n o m a U s e r M a n u a l 8
C H A P T E R T W O
9 S o n o m a U s e r M a n u a l
B A S I C I N S T A L L A T I O N
Installing the Sonoma
FCC NOTICE
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruc-
tion manual, may cause harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmul interference in which case the user will be required to correct the
interference at his own expense.
Using standard 19” rack mounting hardware, mount the unit in the desired location. After mounting
the unit and connecting the antenna cable, verify that it still acquires and tracks a GPS signal.
CAUTION
Ground the unit properly with the supplied power cord.
The socket outlet should be installed near the equipment and be easily accessible.
Power cord is used as a disconnection device. To de-energize equipment, disconnect the power cord. If
your Sonoma has dual power supplies, then multiple power cords may be installed. To de-energize this
equipment, disconnect all power cords from the device.
Do not install the Sonoma N12 where the operating ambient temperature might exceed 122°F (50°C).
Connecting the Optional DC Power
The DC Power Input is an option. For installation instructions see
Chapter 10 - Options, Connecting
the DC Power .
Connecting and Configuring Ethernet
Connect one end of the CAT-5 patch cable supplied with your Sonoma to either of the rear panel
mounted RJ-45 connector labeled 10/100/1000Base-T. Connect the other end of the patch cable to
your network through a ‘straight’ port on your switch. Do not connect it to a ‘crossover’ port on your
switch.
By factory default, the Sonoma will attempt to configure the ethernet interfaces automatically via
the Dynamic Host Configuration Protocol (DHCP). The Sonoma will attempt to set the netmask,
its IP address, the IP address of the default gateway, the domain name and the IP addresses of any
nameservers, if the DHCP server is configured to provide them. You may optionally configure the
Sonoma to also set its hostname via DHCP, if your DHCP server is configured to provide it. You can
do this by running a simple script called
netconfig
after your unit is up on the network.