Endress+Hauser TOC Analyzer CA79, Руководство по эксплуатации

Страница: 11 / 56

TOC Analyzer CA79 Product description
Hauser 11
4.3.2 Socket assignment (system with two connection sockets)
Output 1
Socket Pin Description
A0046897
1: 4 (0) - 20 mA (GND)
2: 4 (0) - 20 mA (+)
TOC 1 (0 to set limit)
3: 4 (0) - 20 mA (GND)
4: 4 (0) - 20 mA (GND)
Δ conductivity (0 to set limit)
5: Relay
6: Relay
Group error message or limit value overshoot depending on the
selected option
Pin 1/2: Provides an analog signal between 4 and 20 mA for the TOC measured value at
the SAMPLE input between 0 and the limit (to be configured in the Settings menu,
Options 1 tab).
Pin 3/4: Provides an analog signal between 4 and 20 mA for the Δ conductivity value
between 0 and the limit in μS/cm (to be configured in the Settings menu, Service 1 tab).
Pin 5/6: Acts as an NO contact if the configured TOC or conductivity limit value is
exceeded in the "analog output" option, or as an NC contact in the option with a group error
message in the event of a power failure, a reaction of the leak, lamp or pressure sensor
and if one of the two conductivity sensors is over range.
4.3.3 Output 2
Socket Pin Description
A0046897
1: 4 (0) - 20 mA (GND)
2: 4 (0) - 20 mA (+)
TOC 2 (0 to set limit)
3: 4 (0) - 20 mA (GND)
4: 4 (0) - 20 mA (GND)
TOC 3 (0 to set limit)
5: Controller (GND)
6: Controller (+)
Controller input / trigger for 24 V DC
Pin 1/2: Provides an analog signal between 4 and 20 mA for the TOC measured value at
INPUT 2 between 0 and the limit (to be configured in the Settings menu, Options 1 tab).
Pin 3/4: Provides an analog signal between 4 and 20 mA for the TOC measured value at
INPUT 3 between 0 and the limit (to be configured in the Settings menu, Options 1 tab).
Pin 5/6: External controller input / trigger, measurement is active when the voltage is
applied and stops if the voltage is 0 V.
The measured value is updated every minute. During a calibration or the SST, the last value
is displayed until a new measurement is started.