Endress+Hauser Picomag IO-Link, Руководство по эксплуатации

Страница: 19 / 64

Picomag IO-Link Electrical connection
Hauser 19
Internal resistance: 7.5 kΩ
IO-Link configuration version
Option only available for output 1 in the Output 1 →  24 submenu
The measuring device features an IO-Link communication interface with a baud rate of
38,400 and with a second IO function on pin 2. This requires an IO-Link compatible
module (IO-Link master) for operation. The IO-Link communication interface allows direct
access to the process and diagnostics data.
6.3 Connecting the measuring device
NOTICE
The measuring device may only be installed by properly trained technicians.
‣
Comply with national and international regulations regarding the installation of
electrotechnical systems.
‣
Power supply according to EN 50178, SELV, PELV or Class 2.
1. De-energize the system.
2. Connect the measuring device via the connector.
3.
1
A0046190
1 Ground terminal
In the case of non-grounded pipes:
The device must be grounded using the ground terminal accessory.
6.4 Post-connection check
Are cables or the device undamaged (visual inspection)? 
Do the cables have adequate strain relief? 
Is the connector connected correctly? 
Does the supply voltage match the specifications on the measuring device? 
Is the pin assignment of the connector correct? 
Is the potential equalization established correctly? 