Endress+Hauser Micropilot NMR84, Руководство по эксплуатации

Страница: 132 / 256

Operating menu Micropilot NMR84
132 Hauser
"Analog IP" submenu
There is a Analog IP submenu for each Analog I/O module of the device. This
submenu refers to terminals 4 to 8 of this module (the analog input). They are
primarily used to connect an RTD. For terminals 1 to 3 (analog input or output) refer
to →  138.
D
E
F
C
B
A
1
1
1
1 3
2
2 4
1
HR
CDI
WP
on
SIM
2
2
3
3
4
4
1 2 3 4 5 6 7 8
POWER
i
1 2 3 4 5 6 7 8
B
B1-3 B4-8
1 2 3 4 5 6 7 8
C
1 2 3 4 5 6 7 8
C1-3 C4-8
A0032465
 46 Terminals for the "Analog IP" submenu ("B4-8" or "C4-8", respectively)
Navigation  Setup → Advanced setup → Input/output → Analog IP
Operating mode 
Navigation  Setup → Advanced setup → Input/output → Analog IP → Operating mode
Description Defines the operating mode of the analog input.
Selection • Disabled
• RTD temperature input
• Gauge power supply
Factory setting Disabled
Additional information
Read access Operator
Write access Maintenance
RTD type 
Navigation  Setup → Advanced setup → Input/output → Analog IP → RTD type
Prerequisite Operating mode (→  132) = RTD temperature input
Description Defines the type of the connected RTD.