Endress+Hauser Micropilot FMR10, Руководство по эксплуатации

Страница: 9 / 72

Micropilot FMR10 Basic safety instructions
Hauser 9
Danger of burns from contact with surfaces!
‣
In the event of elevated fluid temperatures, ensure protection against contact to
prevent burns.
2.3 Workplace safety
For work on and with the device:
‣
Wear the required personal protective equipment according to federal/national
regulations.
2.4 Operational safety
Risk of injury!
‣
Operate the device only if it is in proper technical condition, free from errors and faults.
‣
The operator is responsible for interference-free operation of the device.
Modifications to the device
Unauthorized modifications to the device are not permitted and can lead to unforeseeable
dangers:
‣
If modifications are nevertheless required, consult with the manufacturer.
Repair
To ensure continued operational safety and reliability:
‣
Carry out repairs on the device only if they are expressly permitted.
‣
Observe federal/national regulations pertaining to the repair of an electrical device.
‣
Use only original spare parts and accessories from the manufacturer.
Hazardous area
To eliminate the risk of danger to persons or the facility when the device is used in the
approval-related area (e.g. explosion protection, pressure equipment safety):
‣
Check the nameplate to verify if the device ordered can be put to its intended use in the
approval-related area.
‣
Observe the specifications in the separate supplementary documentation that is an
integral part of this manual.
2.5 Product safety
This measuring device is designed in accordance with good engineering practice to meet
state-of-the-art safety requirements, has been tested, and left the factory in a condition in
which it is safe to operate. It meets general safety standards and legal requirements.
2.5.1 CE mark
The measuring system meets the legal requirements of the applicable EU Directives. These
are listed in the corresponding EU Declaration of Conformity along with the standards
applied.
Hauser confirms successful testing of the device by affixing to it the CE mark.
2.5.2 EAC conformity
The measuring system meets the legal requirements of the applicable EAC guidelines.
These are listed in the corresponding EAC Declaration of Conformity together with the
standards applied.
Hauser confirms successful testing of the device by affixing to it the EAC mark.