Endress+Hauser Cerabar M, Руководство по эксплуатации

Страница: 69 / 92

Cerabar M, Deltapilot M Overview of the operating menu
Hauser 69
12 Overview of the operating menu
Direct access Description
Parameters in italics cannot be edited (read only parameters). The settings, such as the measuring mode, dry or wet calibration or hardware locking,
determine whether these parameters are displayed.
Expert System Operator code 021 →  41
Instrument info Device tag 022 →  71
Serial number 096 →  71
Firmware version 095 →  71
Ext. order code 097 →  72
Order code 098 →  72
ENP version 099 →  72
Electr. serial no. 121 →  72
Sensor serial no. 122 →  72
Display Language 000 →  51
Format 1st value 004 →  73
Management Enter reset code 124 →  73
Measurement Measuring mode 005 →  51
Basic setup Pos. zero adjust (gauge pres-
sure sensors) 007 →  52
Calib. offset (absolute pressure
sensors) 008 →  74
Damping value 017 →  75
Press. eng. unit 125 →  52
Temp. eng. unit 126 →  75
Sensor temp. 110 →  51
Pressure Set LRV 013 →  76
Set URV 014 →  76
Meas. pressure 020 →  76
Sensor pressure 109 →  77
Corrected pressure 172 →  52
Pressure af. damp 111 →  77
Level Unit before lin 025 →  78
Calibration mode 027 →  78
Empty calib. 028 →  78
Empty pressure
Empty pressure (read only) 029
185 →  79
Full calib. 031 →  79
Full pressure
Full pressure (read only) 032
187 →  79
Level before Lin. 019 →  80
Sensor limits LRL sensor 101 →  80
URL sensor 102 →  80
Sensor trim Lo trim measured 129 →  80
Hi trim measured 130 →  80
Lo trim sensor 131 →  81