Endorphines GHOST 16hp, Руководство пользователя

Страница: 7 / 17

14.
DELAY TIME/DIV KNOB:
manual control of the delay speed,
from short audio rate repeats CCW and longer taps CW. When an external
clock is present at the
CLOCK IN jack, the knob acts as a divider / multiplier
for this clock with the divisors written around the knob on the panel.
15.
TIME CV INPUT JACK:
-5…+5V external CV control for the
speed of the delay’s repetitions, follows 1v/oct tracking. Is summed with the
TIME/DIV knob values when no external CLOCK IN applied. When the delay
is synchronized to external CLOCK IN, that CV sets the clock divider also
summed with the value of TIME/DIV knob.
16.
ROUTING /* BUTTON:
routing chain switching as well as
multifunction shift button. Short presses will cycle through three different
orders of audio effects (see FX CHAIN STRUCTURE). Acts as a ‘shift’ button
when held down while using other controls (shift functions are labeled with
/*
on the panel).
17.
TAP
/TAPS*
BUTTON:
acts as a tap tempo button for the delay
speed. When internal clock is enabled (no patch cable connected) this button
blinks fully lit, shown by the symbol under it: . When external clock is
patched, the button blinks semi-lit shown by the symbol under it: .
Secondary function ( R TAPS ) changes the stereo behavior of the
taps produced by the delay. Available delay tap configurations are:
LRLR: left and right summed, taps 1 and 3 panned left, taps 2 and 4 panned
right.
LRRL: left and right summed, taps 1 and 4 panned left, taps 2 and 3 panned
right.
STEREO: left and right inputs tap independently in their corresponding left
and right outputs. In this mode the total delay time is halved.
18.
CLOCK IN JACK:
0…+5V external input for the clock that sets
the TEMPO of the delay. External clock sets the delay time in sixteenth
notes. Module switches to external clock automatically when a patch cable is
inserted in the
CLOCK IN jack: TAP button blinks semi-lit.
19.
REVERB DRY/WET CV JACK:
0…+5V external CV control
over the DRY/WET MIX OF THE REVERB . Normalled to +5V when no patch
cable is inserted.
20.
REVERB KNOB:
manual control of the REVERB DRY/WET mix
level, acts as attenuator for DRY/WET CV jack.
21.
TAIL
/PREDELAY*
KNOB:
primary function controls the decay of
the REVERB’s TAIL , Secondary function in combination with ROUTING /*