Endorphin.es ANDREW HUANG GHOST 16hp, Руководство пользователя, Страница: 16 / 19


Split your techno 909­style kick drum and apply it into AUDIO IN 1

Set the DISTORTION and COMPRESSOR knobs to own taste, usually around 12
o’clock
 Set the VCF filter type to normal LP/HP and set the filter FREQUENCY knob around 11
o’clock

Apply clock from your sequencer into CLOCK IN jack (typically expected in 16
th
notes)
and set the TIME/DIV knob to obtain desired repeats. Set DELAY DRY/WET and
REPEATS to own taste, usually both around 12 o’clock

Enable REVERSED REVERB by R HOLD/reverse* . Set REVERB DRY/WET
and TAIL to your own taste until you obtain a whooshing sound. For proper groove set the
pre­delay amount by R TAIL/preleday* to approx. 12 o’clock

Apply kick­drum trigger into SIDECHAIN TRIG IN jack. Set the ducking envelope
amount to 50% with R SIDECHAIN to 12 o’clock. Then move SIDECHAIN knob
alone to around 10­11 o’clock to catch the proper pumping time

Mix the sound from AUDIO OUT 1/2 with the original kick drum using a mixer such as
Cockpit 2

TIP: it is best to keep your low end consistent or even better ­ MONO. So when using the
delay to create the rumble, set TAPS DISTRIBUTION to STEREO mode via ROUTING +
TAP to avoid PING­PONG effect or simply only use AUDIO OUT 1 .
GHOST DRONE
ROUTING 3
GHOST structure and multidimensional modulation matrix is capable of producing dark
drones and ephemeral soundscapes full of texture and harmony.

Set the ROUTING mode to the third order ( VCF
→
FX
→
DISTORTION ) when ROUTING
button LED is off when ROUTING button is fully lit
.

Select the COMB FILTER by pressing the R FILTER BUTTON and set the
RESONANCE fully CW
 Patch a variable waveform oscillator into the AUDIO IN 1 , SAW and SQUARE waves
work best. Feed an additional envelope or LFO to the pre VCA input on the GHOST to
create movement. Patch the AUDIO OUT 1/2 to your mixer
 Set DELAY DRY/WET to 80% with REPEATS around 30­40%, adjust the
REPEATS/tone*
by pressing the
R REPEATS
knob to around 13:00 ­ 14:00.
Sync the delay by sending a clock from your sequencer into the
CLOCK IN
and leave
TIME/DIV knob at 12:00
 Set REVERB DRY/WET to 60% with a moderate TAIL amount at around 40%. Adjust
the PRE­DELAY by pressing the
R turning the TAIL/predelay* knob
to
approximately 70­80%