IM4830B Rev B
2
October 9, 2019
SAFETY CONSIDERATIONS
This equipment has been designed and tested in accordance with the following standards:
EN61326-1:2006
Electrical equipment for measurement, control and laboratory use – Group1, Class A
(Emissions)
EN61326-1:2006
Electrical equipment for measurement, control and laboratory use – Industrial Location
Immunity
EN61000-3-2:2006
Electromagnetic compatibility (EMC) – Part 3-2
(+A1/A2)
EN61000-3-3:2008
Electromagnetic compatibility (EMC) – Part 3-3
CFR 47, Class A
Code of Federal Regulations: Pt 15, Subpart B
The 4830B has been tested as an Unintentional radiator (sub part B) and as a Class A product
RADIO AND TELEVISION INTERFERENCE
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the
FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to
correct the interference at his own expense.
In order to maintain compliance with FCC regulations shielded cables must be used with this equipment.
Operation with non-approved equipment or unshielded cables is likely to result in interference to radio & television reception.
This equipment is not designed to be used in potentially explosive environments. It should not be used in the presence of
flammable liquids or gases.
This manual contains information and warnings that must be followed to ensure safety of personnel and the safe operation of the
equipment.
Warnings:
Switch off all power to equipment before connecting or disconnecting the digital interface. Failure to do so may cause damage to
the equipment.
Any adjustment, maintenance or repair, other than detailed within this manual, must be carried out by trained service personnel.
If it is suspected that the correct operation of the equipment is threatened, impaired or otherwise, it must be made safe and free
from further operation until the threat has been removed.
Rohs Compliant
2011/65/EU
Waste Electronic and Electronic Equipment Directive: 2012/19/EU
This product complies with the WEEE Directive (2012/19/EU) marking requirement. The affixed product label (below) indicates that
you must not dispose this electrical/electronic product in domestic household waste.
To return unwanted product for disposal, please contact your local MSS representative.
