8
ENGLISH
LIGHTING THE CHARCOAL
1.
Open the battery compartment lock on the outside of the
grill. To lock or unlock the battery compartment, press
lightly against the handle. The battery compartment can
be pulled out for removal. Insert four AA/LR6 batteries.
Please ensure the correct polarity. Slide the battery
compartment back into the side panel and close it.
2.
Fill the charcoal container completely to the brim with
Enders Beech Charcoal (max. 150 g).
3.
Apply an even, approximately 10 mm-wide ring of the
Enders Ignition Paste around the hole of the ignition
bowl (approx. 20 ml). The ignition bowl is positioned in
the designated recess.
4.
Switch on the fan control knob on the exterior and turn it
to the highest level to begin with (three-dot position). To
prevent the flame from being smothered during the ignition
process, the fan must remain switched on until the charcoal
is glowing completely.
5.
Light the ignition paste. Do not touch the open flame.
6.
Place the filled charcoal container together with the
grease guard on the ignition bowl. Make sure that the
charcoal container is resting evenly on the ignition bowl.
7.
Place the grill grate on the designated holders on the
outer sides. Make sure that the grill grate is supported
evenly.
8.
After approximately 10 minutes, the charcoal will be
glowing completely, and the AURORA is ready for use.
Do
not place food on the grill until the fuel is covered
with a layer of ashes!
You can adjust the grate heat to
suit your needs using the control knob on the side.
3.
4.
5.
6.
8.
5.
SETTING 3
Ignition setting and full load
