2. Enter the vehicle.
, The system will trigger and the siren will sound.
3. Turn the ignition key to the ON position.
4. Press and hold the override switch until the alarm shuts off.
The system will disarm.
5. The vehicle will now be able to start.
Optional Coded Emergency Override
As an extra measure of security, the system is equipped with an optional Coded
Emergency Override feature. Once an Emergency Override Code is chosen and
programmed during installation, the system can No longer be disarmed using the
standard override procedure.
To Emergency override the system using the Code:
1. Follow steps 1-3 above.
2. Press the override switch a number of times equal to the Disarm code, and
continue holding for 10 seconds on the last press,
The system will disarm, If the code is entered incorrectly, turn off the ignition and
begin again.
To set the Emergency override Code:
1. Turn on ignition.
2. Within 5 seconds, press the valet switch 5 times.
The siren will provide one long chirp, indicating that you have entered
Programming.
3. Press the valet switch 3 times.
The siren will chirp each time the valet switch is pressed.
4. Within 5 seconds, press Button 3 on the transmitter.
The siren will chirp 3 times.
5. Press the valet switch the number of times equal to the desired code
(from 1-15 )
6. Turn off the ignition then arm the system.
7. Disarm the system using the new Override Code to permanently store the
new code.
Note: If the code set procedure is not properly performed, turn off the ignition and
begin again. The override code will not be permanently stored until the code is
used to disarm the system.