Encore 34K350Z, Руководство оператора

Страница: 8 / 20

ENCORE
C-1
ASSEMBLY
INSTRUCTIONS
Remove unit from crate, taking care to remove
inner boxes and the small parts box.
1.
Remove deflector chute, bolt bag and operator’s
manual from main assembly.
2.
Open bolt bag and lay out the following bolts:
(8) 5/16” -18 x 3/4” HHCS
(4) 5/16” lock washers
(4) 5/16” nyloc nuts
(4) 5/16” -18 whizlock nuts
3.
Taking four of the 5/16” -18 x 3/4” bolts and four of
the 5/16” lock washers, attach the seat to the seat
plate.
4.
Using the remaining bolts and whizlock nuts, bolt
the control levers onto the
outsides of the mount
angles, adjusting them according to operator
comfort.
5.
With the operator’s seat in the raised position
locate the two lead seat switch wire located in the
seat frame. Attach the two leads to the seat switch
located on the under-side of the seat.
6.
Fill engine crank case as per engine
manufacturer’s manual. The engine
DOES NOT
have oil in the crankcase from the factory.
7. Raise the unit slightly and place a board under
each rear wheel. With the deck in the raised
position start the unit and drive it off the pallet.
Once you are familiar with the contents of this
manual, you are ready to mow with the finest
mower built!
Before Operatng -
Remnders
Fill engine crankcase as per engine manufacturer’s
manual.
ENGINE DOES NOT HAVE OIL IN
CRANKCASE FROM THE FACTORY. Add proper
fuel to fuel tank, open shut-off valve.
The battery is now a gel-cell and w
ill not require
acid.
Before hooking up the ground wires make sure that
the engine has been filled to the proper level with oil.
If battery will not turn the engine over after hooking the
wires up it may require a charge for 15 to 20 minutes.
STARTING ENGINE
Throttle control, ignition switch and choke control are
located between motion control levers on the front
panel under the front of the seat.
Because of a built-in safety interlock system, your
machine will not start unless the seat is occupied.
TO START ENGINE: occupy seat, set park brake,
leave the motion control levers swung out, move
throttle control lever all way to choke position. Turn
ignition key to start position to engage starter, release
the key when engine starts. Ignition switch is spring
loaded and will return to run position automatically.
Slowly return choke to run position once the engine
has started.
STOPPING ENGINE
TO STOP ENGINE: move throttle lever to idle position
and turn ignition key to “OFF” position. If engine has
been working hard or is hot, allow engine to idle for
a short period of time before turning off key. This
practice will help cool engine before stopping.
IN CASE OF EMERGENCY engine may be stopped
by turning ignition key to “OFF” position.

CAUTION:
Always remove the key and set the parking brake
when leaving the machine unattended, even for just
a few minutes.
PREVENT ACCIDENTS:
Do not give children or
unauthorized persons an opportunity to operate
this machine.

WARNING:
THE ENGINE EXHAUST FROM THIS PRODUCT
CONTAINS CHEMICALS KNOWN IN THE STATE
OF CALIFORNIA TO CAUSE CANCER, BIRTH
DEFECTS OR OTHER REPRODUCTIVE HARMS.

WARNING:
DO NOT allow children to operate the machine. DO
NOT allow any adult to operate the machine without
proper instruction.