Encore 34K350Z, Руководство оператора

Страница: 12 / 20

ENCORE
D-3
BATTERY
The battery is located under the right hand fender
to the rear of the machine. The gel-cell battery is
maintenance free.

CAUTION:
When servicing the battery or any other part of the
electrical system, or if the battery must be removed
for any reason, always, disconnect negative (ground)
cable FIRST and reconnect it LAST to avoid possibility
of electrical shorts.
At temperatures below 32° F (0° C), full charge state
must be maintained to prevent cell electrolyte from
freezing and causing permanent battery damage.
For longest service life, battery should be kept clean by
wiping it off with a paper towel. Any corrosion around
battery should be removed by applying a solution of
one part baking soda to four parts water. A light coating
of grease or petroleum jelly may be applied to all
exposed terminal surfaces to prevent corrosion.
Belt Adjustment
Remove key from the ignition switch. The blade
drive belt and the deck drive belt may be accessed
by raising the foot plate. Each of these belts have an
eyebolt for adjusting spring tension.
See Figure 4.
Spring tension should be maintained by having
approximately 1/8” stretch between coils. By turning
the nut on the eyebolt clockwise you increase the
tension, counter clockwise will decrease tension.
When installing a belt please refer to the following
figure 5 for routing the belt.
A
B B
A: Deck Drive Belt Tensioner eyebolt
B: Blade Drive Belt Tensioner eyebolt
Figure 4
BELT ROUTING
TO FRONT OF MOWER
Simplied View
Top View of the Deck
Blade Drive Belt
343018
Figure 5