Encore 34K350Z, Руководство оператора

Страница: 11 / 20

ENCORE
D-2
MAINTENANCE INFO
1. Do not adjust mower or change attachments
unless the engine has been stopped and the key
has been removed.
2. Good maintenance, wiping up gasoline and oil
spills, will reduce potential fire hazards.
3. To insure that the mower will remain in safe
operating condition, check and tighten all bolts,
nuts and screws. Especially make certain the
blade bolt/nuts are always tightened properly.
4. Never adjust governor on engine to a faster speed.
The engine manufacturer adjusts the engine RPM
to the proper setting.
5. Allow time for the engine to cool down prior to
storing mower. Do not store mower or gasoline
near any open flame or where gasoline fumes may
be ignited.
6. Always replace worn or broken parts with genuine
Encore repair parts purchased from an authorized
Encore dealer. Using anything other than Encore
repair parts may void all Encore factory warranties.

CAUTION:
DO NOT SPILL OIL OR GREASE ON BELTS.
OIL AND FILTER
Since the hydraulic drives on the Z34 Rider are lifetime
lubricated there are no required filter and or oil changes
required. Please refer to the engine manual for engine
lubrication recommendations.
TIRE PRESSURE
This vehicle has been designed to achieve maximum
operator comfort and ride. This cannot be achieved
without proper tire pressure. A low pressure gauge is
required to check the front tires.
Front Tires - 14 PSI
Rear Tires - 20 PSI
NOTES:
The Encore Rider is driven and steered by the rear
wheels.
REAR TIRE CIRCUMFERENCE DIRECTLY EFFECTS
THE TRACKING OF THE MACHINE.
If the machine will not drive in a straight line, check
air pressure and adjust accordingly.
Description of Maintenance Task Service Intervals
Blades - sharpen & securely fastened to 65 ft-lbs Daily
Check fuel level Daily
Discharge chute - securely in place & in lowest
position
Daily
Verify safety start interlock system Daily
Visually inspect tires Daily
Visually inspect unit for loose hardware and/or
damaged parts
Daily
Check battery connections Every 50 hours
Check tire pressure with a guage Every 50 hours
Check pump drive belt tension & condition Every 100 hours
Check blade drive belt tension & condition Every 100 hours
Check deck drive belt tension & condition Every 100 hours
Tighten lug nuts on wheels Every 100 hours
Check oil level in engine See Note A
Change engine oil & filter See Note A
Change fuel filter See Note A
Clean air intake screen See Note A
Clean cylinder / head fins See Note A
Clean foam element See Note A
Clean paper element See Note A
Replace air cleaner paper element See Note A
Clean and regap or replace spark plugs See Note A
Note:
A. Refer to Supplied Engine Manufactures Owner’s Manual for all maintance
and engine manufactures warranty policy information
Lubrcaton
The following recommendations on lubrication chart
below should be adhered to. Environmental conditions
may be cause to vary frequency. Grease points are
pointed out in Figure 2.