6
VSR-30™ Installation Guide
3
Select one of the listed set-ups.
❖
The menu for the selected set-up (scenario) is displayed. (The menu shown is for an
Ethernet WAN SLE Gateway, Initiator
.)
Note:
At this point, all IP addresses, etc., have null values. Before you can load the
configuration into the VSR, you must enter values that reflect your network’s settings.
4
For each item (parameter) in the menu, do the following:
a
Select the item (for example, WAN Interface IP).
b
Type a value for the item, and press Enter.
c
If the item requests additional information, enter that information.
❖
When the item has been configured, the scenario’s menu is displayed again.
VSR-30
Startup Configuration Scenarios
---------------------------------------
1) Ethernet WAN SLE Gateway(Initiator)
2) Ethernet WAN SLE Gateway(Initiator) With Dial Backup
3) Ethernet WAN SLE Gateway(Terminator)
4) Ethernet WAN SLE Gateway(Terminator) With Dial Backup
Enter Choice :
VSR-30
Startup Configuration Parameters
---------------------------------
1) System Name :
2) LAN Interface IP : 0.0.0.0 /0.0.0.0 No DHCP Server
3) LAN Private NAT IP : 0.0.0.0 /0.0.0.0 masq:0.0.0.0
4) WAN Interface IP : Dynamic
5) Primary DNS Server : 0.0.0.0
6) VPN Gateway :
7) VPN User ID :
8) VPN Pre-Shared Key :
9) Application Clients IP : 0.0.0.0
L) Load Above Config
V) reView/Modify Loaded Config
R) Reset (Write and Reset)
Z) Clear All Fields
Enter Choice :
Enter IP Address :
