ENCAD T-200, Руководство по обслуживанию

Страница: 74 / 162

ENCAD T-200 and T-200+ Service Manual
Maintenance 3-34
The “Color Horizontal Head-to-Head Calibration” checks the alignment
of the nozzles horizontally and allows corrections when required. Just
enter the value below the set of lines that are correctly aligned. Be
careful that you are aligning the correct color by observing the C (cyan),
M (magenta), and Y (yellow) on the right side of the plot.
The “Color Vertical Head-to-Head Calibration” checks the alignment of
the nozzles vertically and allows corrections when required. Just enter
the value below the set of lines that are correctly aligned. Be careful
that you are aligning the correct color by observing the C (cyan), M
(magenta), and Y (yellow) on the right side of the plot.
To perform the Color Calibration:
Depress the “Menu” key on the control panel to begin the main
menu subroutine.
Using the “Up Arrow”, Down Arrow” and “Select” keys on the
control panel select:
Utility Menu
Color Calib
Print Test
This will print the color calibration plot as shown in Figure 3-25.
When the plot is complete, use the “Up Arrow”, Down Arrow” and
“Select” keys on the control panel to select “C Vert= XX ”.
Observe the plot and using either “Up Arrow” or “Down Arrow”,
rotate through the selections until the one that best aligns the
cyan color on the plot is selected. Press “Select” to accept the
selection and return to the Color Calib Subroutine.
Continue until all six calibrations on the Color Calib Menu have
been accomplished.