ENCAD T-200, Руководство по обслуживанию

Страница: 109 / 162

ENCAD T-200 and T-200+ Service Manual
Assembly\Disassembly 5-7
4. While holding the Right Side Plate, remove the screws securing
the side plate to the Platen. See Figure 5-3.
5. Slowly pull the Right Side Plate away from the Platen while
feeding the cables through the side plate.
Reinstalling the Right Side Plate
To reinstall the Right Side Plate, reverse the steps followed when
removing the Right Side Plate:
1. Feed the cables through the appropriate holes in the side plate
then hold it in place against the Platen.
2. Reinstall the Right Side Plate to the Platen by securing with the
screws. Torque to 15 in-lbs.
3. Reinstall the MPWA and all MPWA connections.
4. Reinstall the Right Cover Assembly and the Top Cover.
Reinstalling the MPWA
To reinstall the MPWA, reverse the steps followed when removing the
MPWA:
1. Put on an ESD wrist strap.
2. Remove the MPWA from the ESD bag.
3. Hold the MPWA in place on the Right Side Plate while putting in
the correct three screws in the holes located on Figure 5-2. Use a
#2 Phillips screwdriver to torque the screws to 6 in-lbs.
Reinstalling the MPWA Connectors
1. Reinstall the Stepper Motor connector at J10.
2. Reinstall the Fan connector (Red and Black wires) at J5.
3. Reinstall the Servo Motor connector (Red and Blue wires) at J7.