ENCAD T-200, Руководство по обслуживанию

Страница: 145 / 162

ENCAD T-200 and T-200+ Service Manual
Assembly\Disassembly 5-43
11. Hold the Fan in place with your left hand and insert the screws.
Make sure that the screws go in straight. Using a #2 6” or
8” Phillips screwdriver, torque them to 15 in-lbs. Do not
overtighten or the threads on the screw holes will strip.
12. Reinstall the Exhaust on the outside of the bottom of the Platen.
Using a #2 6” or 8” Phillips screwdriver, torque to 8 in-lbs.
13. Reinsert the Snap Plug in the bottom of the Platen and turn the
Platen onto its bottom side.
Reassembly of Plotter After Reinstalling the Inner
Platen Parts
1. Reinstall the Servo Motor.
2. Reinstall the Display Assembly.
3. Reinstall the Service Station Assembly.
4. Make sure the Ground from the Power Cable is still connected to
the inside of the Platen, at the same location as the ON/OFF
Switch Ground. Reinstall the Power Supply.
5. Reinstall the Left and Right Rollguides.
6. Route all the wires from the Servo Motor Assembly, Stepper Motor
Assembly, Fan Assembly, and Power Supply through the bottom
opening on the Right Side Plate. See Figure 5-23. Secure the
Right Side Plate to the Platen with four screws. See Figure 5-3.
8. Route the Trailing Cable (with the silver fingers facing up)
through the top slot in the Right Side Plate.
9. Secure the MPWA to the Right Side Plate using three screws.
Make sure the Trailing Cable is not pinched between the stand off
and the MPWA.
10. Bring the Trailing Cable around the bottom of the MPWA and
connect it at the J6 connector. Make sure the silver fingers
face down when the Trailing Cable is inserted into the
connector.