4
BEFORE USE PREPARATION
1.
Ensure that all hoses are free from dust or other contaminants before connecting.
2.
Connect one end of 10 cm hose to an air inlet (either one) of Enaly Air Dryer.
3.
Connect the other end of 10 cm hose to the air inlet of the unit.
WARNING: Avoid using a hose longer than 10 cm to make the connection to Enaly Air
Dryer. An overly long hose can overload the internal air pump and cause a
premature failure.
4.1
For water/liquid treatments, connect the 100 cm hose to the ozone outlet and a diffuser
stone to the other end of hose.
4.2
For air treatment, it is recommended to run without the hose connecting to the ozone outlet.
5.
Plug in the power plug into a power outlet.
WARNING: Use only the rated voltage indicated on the product information label. The
product information label is affixed on the case.
OPERATING THE UNIT
1.
Switch the power switch to turn the power on. The LED Display will indicate a timer time
last set or “ON”(“60”min is shown for the first time use)
2.
Turning the ozone output adjuster to adjust ozone output. The unit will produce its
maximum ozone output when the ozone output adjuster is at its maximum position. The
ozone output is decreasing from its maximum level as the ozone output adjuster is being
turned counter-wisely. The minimum ozone level is less than 40% of the max. output.
(Either follow step 3.1 or 3.2)
3.1
Using the Timer:
3.1a
Press the UP key or the DOWN key once to either increase or decrease the timer
time by 5 min. Press repeatedly until you reach the desired timer time. The
maximum timer time is 60 min. The minimum timer time is 0 min (displaying
“00”).
3.1b
Press the ON/OFF key to start working. The timer time starts blinking and
counting down in a 5-minute interval. When the timer time reaches “00”the
unit will stop. After 3 sec the LED will again indicate the timer time last set.
3.1c
To pause timing, press the ON/OFF key
（
This will pause working too
）
. The
LED display will indicate the timer time last shown before the pause.
To resume timing, press ON/OFF key again.
OR
To stop working immediately, switch the power switch to turn the power off.
To restart, repeat from the step1.
Note:
When the timer time is set at “00”, ON/OFF key is not functioning.
To adjust the timer time during count-down either press or UP or Down key.
To switch to the Constant-On mode when it is working under timer mode, press
and hold the ON/OFF key for 3 sec.
If the timer was last used before turning the power off, after turning the power
on, the LED will indicate a timer time last set.
