I
NSTALLING
T
HE
865W PRO G
IGABIT
P
O
E E
XTENDER
he Enable-IT 865W PRO Gigabit PoE Extenders have a distance reach of up to 3,000ft (915m)
over any 1-pair wiring (Telephone, Coax, or Category rated) between the 865W PRO units. You
can add additional 328ft (100m) onto the end of each 865W PRO LAN output ports for a total
distance of 3,000ft (915m) from device extension to device extension. Therefore a site survey
of the wiring and installation planning are highly recommended. For highest performance use
lower gauge wiring like 14AWG ~ 24AWG for the interlink wiring.
We highly recommend that you perform a quick out of the box test to ensure the working order of your
Enable-IT 865W PRO Gigabit PoE Extender units prior to installing. This will also serve to familiarize
you with how easy the process should be. Follow the steps below to perform the Out Of the Box Test.
Step 1
- Attach the 865W PRO 60W 56V PoE injector to the 865W PRO CO unit and to your AC outlet.
The Power LED will indicate the 865W PRO CO unit is receiving power.
Step 2
- Connect the 865W PRO units together using one of the Ethernet LAN Patch cords provided – attach
to the RJ-45 Interlink port on each 865W PRO unit as shown by the green line connecting the
(Interlink) ports in the diagram above. The 865W PRO CO unit will have a solid Link LED when
connected to the Extender unit successfully.
Step 3
- Attach and test and to confirm your PoE Equipment works through the 865W PRO extension, connect
your Ethernet LAN to the 865W PRO Injector unit LAN port and the remote device/s to the 865W PRO
Extender LAN port and test connectivity.
This confirms basic proper operation of the units.
Performing the On-Site Installation
After removing the Enable-IT 865W PRO Gigabit PoE Extender Kit from the box, and
performing the Out Of The Box Testing (OOTBT), all that remains to install the unit on-site is to
mount the unit, build the interconnect wiring, add voice lines if needed, and attach the LAN
device cabling with the provided Ethernet Patch cords.
Mounting the Enable-IT 865W PRO Gigabit PoE Extender Units
The Enable-IT 865W PRO extended Ethernet solution is designed for quick wall mounting.
Choose a location to mount each of the Enable-IT 865W PRO’s where the maximum distance
does not exceed
3,000ft (915m)
total between devices to be connected. When wall-mounting
the Enable-IT 865W PRO unit it is recommended that you use the appropriate screw anchors
for your mounting surface. If mounting on existing plywood use wood screws; if mounting onto
drywall or sheetrock, use plastic drywall anchors to secure your installation.
All Rights Reserved © 1997 - 2019 Enable-IT
™
, Inc. Page of
2
6
