Mounting the Enable-IT 821W Waterproof Ethernet Extender Units
The Enable-IT 821W Waterproof extended Ethernet solution is designed for quick wall
mounting. Choose a location to mount each of the Enable-IT 821W Waterproof’s where the
maximum distance does not exceed
2,306ft (702m)
total between devices to be connected.
When wall-mounting the Enable-IT 821W Waterproof unit it is recommended that you use the
appropriate screw anchors for your mounting surface. If mounting on existing plywood use
wood screws; if mounting onto drywall or sheetrock, use plastic drywall anchors to secure your
installation.
Building the 821W Waterproof LRP Interlink Wiring
The most important aspect of the installation is the correct wiring of the Interlink cabling.
The 821W Waterproof LRP Interlink port (RJ-45 interface) carries this 1-pair signaling and
power over the RJ-45 (pins 1 & 2) - used as transport. If you use more than 1-pair of wiring,
such as a CAT5 segment, the remaining RJ-45 pins can transport native 802.3f / 802.3at PoE,
or are unused.
For all wiring you will need to crimp a RJ-45 Male head to each end of the contiguous wire run
and using the following (pins 1 & 2) straight through. We recommend using a category rated
twisted pair cable as it is optimized for high throughput frequencies isolated from cross-talk
noise. Insert the completed RJ-45 ends into the 821W Waterproof LRP Interlink port on each
821W Waterproof unit.
Cabling Devices to The Enable-IT 821W Waterproof Extended Ethernet Kit
Attach your remote LAN device to the 821W Waterproof Extender unit LAN port with Ethernet
patch cord provided. Attach your local LAN to the 821W Waterproof Injector LAN port with
Ethernet patch cord provided. Attach the 56V - 65W power adapter to the 821W Waterproof
Injector unit.
Attach your local LRP Interlink cabling end to the 821W Waterproof Injector unit LRP Interlink
port – Then do the same for the remote end and plug into the 821W Waterproof Extender unit
LRP Interlink port. The Interlink side Green Sync LED should be solid, indicating is sees the
remote partner. There is no sync delay! Your equipment should now be powered up and
functioning.
The LED indicators will provide visual operational status of the 821W Waterproof Ethernet
Extender units.
All Rights Reserved © 1997 - 2020 Enable-IT
™
, Inc. Page
!
of
!
3
7
821W Waterproof Extender
821 Injector
RJ-45 LRP Interlink Cabling up to 1,650ft (500m)
Pin 1 & 2
Pin 1 & 2
RJ-45 Head