Command Reference Guide 11
Initialize
Initialize NETQue printer servers and NETJet printer servers installed in
Hewlett-Packard printers with MIO version 6.0 or above.
>
Server>> initialize [
server
] [
delay
delay_min
]
[
cancel
] [
flash
] [
default
] [
disabled
]
server
Reinitializes the printer server.
delay
Indicates reinitialization will not take place until
after a specified period of time.
delay_min
A number specifying the amount of delay in
minutes. The default is 1 minute.
cancel
Cancels a previously entered initialize command
if entered within the delay time specified in the
initial command.
flash
Causes printer server software to download
from the host to flash memory if the printer
server is configured for a network load.
default
Resets the printer server to factory defaults. IP
address and subnet mask are reset to none.
disabled
Prevents any connections after initialization. To
enable connections, enter the initialize
command through a remote console without this
option.
When the initialize printer server command is issued with a delay, a
warning message is sent every 30 minutes to all logged in ports. Five
minutes before initialization, the warning is broadcast every minute.
When the printer server is reinitialized, all options modified by Set
commands are reset to their permanent values, and all options modified
by Change and Define commands take effect.
Below MIO Version 6.0
The initialize command will not reset NETJet printer servers in Hewlett
Packard printers that do not have MIO version 6.0 or above. To reset
these printer servers, recycle power on the printer.
