Installation
Caution Emulex LightPulse ® Host Bus Adapters (HBAs) contain
electronic components that can be damaged by static
electricity through an electrostatic discharge (ESD) event. To
prevent ESD damage, maintain constant contact with any
grounded metal surface. A grounding wrist strap is useful for
this purpose. Handle the card carefully at all times and
preferably by the edges. Avoid touching electronic
components and keep the card in the original packaging until
you are ready for installation.
Compatibility
Software
Environments
Solaris (Sparc)
Hardware
Environments
Sun Enterprise (Ultra) servers ES3500, ES4500, ES5500,
ES6500 and UE10K
Prerequisites
Host computer must provide 5VDC and 12VDC bus power
•
One open 32 or 64−bit data SBus slot with a 5.0 VDC signaling interface
•
Maximum SBus clock rate of 25 MHz
•
Media and connectors
•
Note
The LP9002S supports both a 32− and 64−bit bus, but not in
all transfer modes. For 32−bit slave mode, both 4 byte or less
and burst mode transfers are supported. For 32−bit DMA
mode, only 4 byte or less transfers are supported. For 64−bit,
all transfer modes are supported. The SBus is limited to
64−byte (max.) bursts for 32−bit bus and 128−byte (max.)
bursts for 64−bit bus, in a single bus tenure. Hence,
maximum burst rate is the same as sustained, assuming no
intervening bus tenures from alternate SBus masters.
Emulex Drivers, Software and Manuals
3
