Install the Host Bus Adapter Board
Record IEEE and serial numbers.
Each host bus adapter port is shipped with a unique address identifier
called the IEEE address. Since this adapter has two ports, there are two
IEEE addresses. The IEEE address is used when configuring your
system. The serial number is used when communicating with Emulex.
All numbers are clearly marked on the board. We recommend that you
record these numbers before installing the adapter.
1.
Turn off the computer.
2.
Caution This adapter does not support insertion into a
powered−on backplane.
Remove the blank panel from an empty 32− or 64−bit cPCI bus slot, or
remove the existing HBA.
3.
With the lever open, hold the LP9002C board by the two side edges or
the bracket, and slide the card into the slot between the two guides.
4.
Caution Do not hold, pull, or push the host bus adapter
board by the lever lock. The lever lock is not
designed to be used as a handle. Hold the board by
the front panel or edges only.
Press on the front panel to completely seat the card in the I/O
assembly.Push the lever in to lock the lever. You should feel it click.
5.
Emulex Drivers, Software and Manuals
5