LP11002 Hardware Installation Manual
Page 3
Setting the Jumpers
The device ID jumpers are used in custom applications. Do not change the jumper settings for a
standard Emulex installation.
The host adapter has two six-post jumper blocks, one jumper block for each port, that control the host
adapter's device ID. The ID is selected by installing a jumper between posts 1 and 2, or 3 and 4, or 5
and 6. If no jumper is installed, the host bus adapter reports a device ID of 1AE5 for each channel. Port
0 is the top transceiver, and port 1 is the bottom transceiver.
Figure 1: The LP11002 HBA Jumper Settings
Caution: Emulex LightPulse® HBAs contain electronic components that can be damaged by static electricity
through an electrostatic discharge (ESD) event. To prevent ESD damage, maintain constant
contact with any grounded metal surface. A grounding wrist strap is useful for this purpose. Handle
the card carefully at all times and preferably by the edges. Avoid touching electronic components
and keep the card in the original packaging until you are ready for installation.
Table 2: Jumper Settings (Port 0 and Port 1)
PCI Identifier
P0_JX (Port 0)
P1_JX (Port 1)
FD00
1–2
1–2
FD01
3–4
3–4
1AE5*
5–6
5–6
Note: * Without a jumper, the HBA reports a device ID of 1AE5. Most software drivers
require a PCI device ID of FD00 to properly identify and control the HBA. Do not
attempt to operate the HBA with the PCI device ID set to 1AE5 unless recommended
by the driver installation instructions.
Содержание LP11002
Страница 1: ...LP11002 HBA Installation Manual...
Страница 13: ...LP11002 Hardware Installation Manual Page 10...