Emulex LP1005DC-CM2, Руководство по установке

Страница: 6 / 13

LP1005DC-CM2 Hardware Installation Manual Page 3
Installing the Host Bus Adapter
To install the HBA:
1. Each host bus adapter is shipped with a unique 64-bit identifier called the IEEE address. The
Fibre Channel industry uses a World Wide Name (WWN) derived from the IEEE address, and
this number is needed for Fibre Channel connectivity. Since this adapter has two ports, there are
two IEEE addresses. The IEEE address is used when configuring your system. The serial
number is used when communicating with Emulex. All numbers are clearly marked on the board.
We recommend that you record these numbers before installation.
2. Remove the Blade Server from the BladeCenter server bay in which you want to install the LP1005DC-CM2
HBA.
Figure 1: The Blade Server. (HS20 or similar server type depicted.)
3. To remove the Blade Server cover, follow the instructions on the blade cover.
Caution: Emulex LightPulse® HBAs contain electronic components
that can be damaged by static electricity through an
electrostatic discharge (ESD) event. To prevent ESD
damage, maintain constant contact with any grounded metal
surface. A grounding wrist strap is useful for this purpose.
Handle the card carefully at all times and preferably by the
edges. Avoid touching electronic components and keep the
card in the original packaging until you are ready for
installation.
Note: Please refer to the "Fibre Channel Expansion Card Installation and User's Guide"
contained on the IBM BladeCenter Documentation CD for further information
regarding installation.
Note: If an IDE hard disk drive is installed in the IDE connector location where you are
installing the I/O expansion card, you must remove the drive, riser card, and tray
(remember to save the screws that secure the tray to the system board); otherwise,
remove the two screws near the IDE connector, if they are present.