EMTEST BS 200N100, Руководство пользователя

Страница: 8 / 21

AMETEK CTS BS 200N100
Operating manual V 1.12 8 / 21
4. Technical Data
4.1. Technical data BS 200N100 and BS 200N100.1
Test voltage
Operating voltage Max. 60 V
Operating current Max. 100 A continuous
Peak current protection 500 A
Inrush current 400 A for 200 ms
Voltage drop Less than 0.2 V @ 25 A
Less than 1.2 V @ 100 A
Peak voltage Typ. 1300 V
Overvoltage protection By varistor
Overvload protection short
– circuit over temperature protected
switch off after approx. 2 min with 120 A;
switch on after approx.. 45 s cooling time.
Inverse polarity protection Protected with an additional acoustic signal in case of inverse polarity
Electronic switch
Switching time
300 ns

20% (240 ns
– 360 ns) into test load 50

H/0.6

On/Off duration Min. 10 ms to 500 ms continuously selectable by potentiometer ± 5%
On/Off repetition Min. 1 s to 10 s continuously selectable by potentiometer ± 5%
Operation Switch closed indicated by LED
Output noise < 400 mV peak, (typical 300 mV)
Trigger
Manual Manual trigger of a single event
Auto
Automatic trigger with min.

0.1 Hz to max. 1 Hz repetition, continuously
selectable by potentiometer
Extern
External trigger

0V, BNC input (Umax. +15 V)
External LV124 Mode Active when Manual Trigger button is pressed during
“Power ON”
Trigger delay typical Switch off: approx. 10.5 us
Switch on: approx. 94 ms
Measurement
Voltage monitor
BNC output; differential divider 1:200,

5%; Bandwidth 10 MHz
CRO trigger
BNC output,

0 V
General data
Output connector 50mm above GND plane
Connector DUT 6mm high current connector 100 A, 4 mm safety lab connectors 32 A
Dimensions 90 mm x 125 mm x 120 mm (L x W x H);
Weight 1.30 kg
Supply voltage 24V DC via mains supply adapter