Page 5 of 20
Caring for your laminator
Don’t leave hard items on the feed table, if they are pulled into the rollers they will cause extensive
non-warranty damage to the rollers.
Don’t cut against the rollers. Any sharp instrument should be used
with extreme caution, as the rubber rollers are easily damaged with knives.
Laminate only flat and even items.
If dirty, rollers may be cleaned with a small amount of Kerosene on a soft cloth.
Do not use a scouring pad or abrasive cleaners. Do not soak the rollers with kerosene.
Do not use excessive brake pressure - you should be able to turn the rolls of film with one hand.
Do not leave the laminator on for extended periods if it is not being used. Turn the temperature
control off when the machine is not to be used for more than an hour.
Keep the temperature below 160 degrees celsius / 320 degrees Fahrenheit. Higher temperatures will
cause damage to the rollers.
Never cut against
the rollers.
The Control Panel
Speed control
Foot / Continuous switch (if fitted)
Forward / Reverse
Cooling Fans
Temperature control
Heat indicator.
Adjusts the motor speed. Clicks into `off’ position when turned
all the way counter clockwise
Allows you to select footswitch mode or continuous motor
mode. In footswitch mode, the rollers only turn when the foot
switch is depressed.
Reverse is mainly used in the unlikely event of a film wrap up. Do
not change from forward to reverse while the motor is in operation.
Cooling fans are used to prevent distortion during thermal
laminating. If no footswitch is fitted, this will be in position 2.
A simple thermostat control - dial the required temperature and
wait for the heat indicator to turn off.
This light will be on while the machine is heating, and off once
it reaches temperature. It will turn on and off during normal
operation as the thermostat maintains temperature.
1
1
2
2
3
3
4
4
5
5
6
6
Содержание Centaur
Страница 1: ...Assembly Operators Manual ...