Page 4 of 20
Parts of the Centaur
Setting up the Centaur
1
5
2
6
3
4
1.
2.
3.
4.
5.
6.
Control Panel
Rollers
Feed table
Emergency Stop switch
Upper mandrel
Lower mandrel
7. Idler bars
8. Rewind mandrel
Positioning the Centaur
It is important to select an appropriate work area for the Centaur. The following are guidles to
selecting the best position.
Make sure the work area is well lit and ventilated.
Keep the machine out of drafts such as air conditioners, open windows and doorways. Drafts
will cool the film during thermal lamination and cause poor results.
Try to keep the machine in a clean environment. Dust will cause noticeable marks on
laminated items.
Make sure that the front and back of the machine are easily accessible. The laminated items
leaving the back of the machine should be able to either fall to the floor or exit onto a table
Keep power cords and the footswitch cable out of the way to avoid tripping.
Unpacking the Centaur
1. Remove the mobile stand from the box and assemble as shown in in the instructions.
2. Lift the laminator from the box. At least two people are required to lift this machine. Remember to
bend your knees when lifting.
3. Remove the plastic covering. Place the laminator on the mobile stand and attach the securing bolts.
DO NOT LIFT BY IDLER BARS OR ROLLERS - THIS WILL CAUSE
DAMAGE AND VOID WARRANTY. ALWAYS LIFT FROM BOTTOM OF SIDE CASES.
7
7
8
Содержание Centaur
Страница 1: ...Assembly Operators Manual ...