Emseal Centaur, Руководство по сборке и эксплуатации

Страница: 13 / 22

Page 10 of 20
Step 1
Make sure the thermostat is set to 0.
Load the rolls as shown. Makre sure
that the film side of the laminate is
against the table, with the release
paper facing upwards.
The core adapters on the mandrel are
designed to slide into the roll, but grip
when the core turns. Rotating the
mandrel slightly left and right as you
slide it into the core can help make this
easier.
Step 2
Position the rolls as shown on in the diagram on page 9.
Step 3
Pull the film from the supply roll forward,
passing under the chrome idler bar. It should
now be lying across the top roller, with the
release paper facing upwards and the laminate
lying against the roller.
Separate the release paper from the film, and
attach it to the core. You can use adhesive
tape or a stapler.
The exposed film should be lying on the top
roller, with the adhesive facing towards you,
Film travels under
chrome idler bar. Release paper attached
to rewind core.
Pressure sensitive laminating - loading
Supply mandrel
Loop belt around small pulley and stretch
to top of large pulley. Rotate the large pulley to stretch the
belt into the pulley groove. The belt is now in position and the
rewind function is now ready for use.
Underlay paper
Rewind Core
Step 4 - The rewind belt