EMS SmartCell, Руководство по программированию

Страница: 22 / 80

©2020 EMS Ltd. All rights reserved. Page 22 of 80 MK067-0001-99 (Issue 1) 04/11/2020 AJM
System setup introduction
This system setup section will show you how to configure the WZM and connect it to a fire alarm panel. The
‘at WZM’ (via power-up) method of adding devices to the WZM will be used. For advanced programming,
refer to the ‘Panel Menus’ section of this document.
Important system setup notes
The installation must conform to applicable local installation codes and should only be
installed by a fully trained competent person.
!
SmartCell devices contain electronics that may be susceptible to damage from Electro
Static Discharge (ESD). Take appropriate precautions when handling electronic boards.
The procedures outlined in this installation guide must be carefully followed.
Always select an appropriate device type for the application as per local codes of practice,
or as advised by a qualified professional.
Side cover removal
The following steps illustrate how to remove the side covers:
Slide the side cover sideways,
creating a gap as shown.
Press the cover’s releasing clip
with your thumb (A), and
simultaneously rotate the side
cover anti-clockwise (B), as
viewed overhead to remove the
cover.
Position your fingers behind
the cover’s protruding edge.
1. 2. 3.
(A) (A)
(B)
To ensure correct operation, products must be used within the specified environmental
operating conditions.