EMS SYSTEM 7000
©2015 EMS Security Group Ltd. All rights reserved. TSD248 Iss 2 25/06/15 AJM
17
8.8 If the type requires changing, from the command menu type
type
and press the
enter key. The display will then show:-
Input Number 1 is Alarm
Change Y/N ?
To change press Y and then enter. The display will then change to the following:
Enter new type 0 = NU, 1 = RESET
2 = LOWBAT, 3 = TAMPER, 4 = LOCAL, 5 = ALARM
Enter the required number and press enter. The display will now show:
Input Number 1 is NNNNNN ( Where N is the new option chosen)
Input Number 2 is Alarm
Change Y/N ?
If you don’t require the input to be changed press N or Enter. The display will then
change to show the next input.
This continues until all 8 contacts are looked at. On answering Y/N to contact 8 the
display will change to show the command menu. To check settings type
type
to re-
enter menu.
9. MODE
9.1
Each of the transmitters inputs have a
mode
setting, which sets the operation of
the input. The unit has two modes contact and hand push. The default for all inputs
is set to contact.
9.2
If contact is selected the input should be added into the IRIS receiver as a N/0
contact operated transmitter, this will then cause the input to transmit data on both
an activation of the input and the reinstating of the input. This will be shown on the
IRIS when its being reset, as it will show which inputs have not transmitted their
restored signals by showing that the input is not reset. This contact setting is only
recommended when the alarm type is set to either a local or alarm transmission.
9.3
If hand push is selected the input should be added into the IRIS receiver as an
opposed action hand push transmitter, this will then cause the input to transmit
data on an activation of the input. This setting can be selected for all alarm types
and is imperative for the correct activation of alarm types low battery, tamper and
reset.
9.4
If the mode requires changing, from the command menu type
mode
and press the
enter key. The display will then show:
Input Number 1 is CONTACT
Change to HANDPUSH Y/N ?
