EMS Imaging XtremeDV-HD4+, Руководство пользователя

Страница: 13 / 16

Firmware Upgrades
11
The XtremeDV-HD4+ cards allow firmware upgrades to be completed on site rather than returning the
card to EMS. Whenever a firmware upgrade is performed, the SW2 on the DIP switch must be set ON.
The DIP Switch can be located on the back of the XtremeDV-HD4+ (See Fig. 6 ). To perform the
upgrade, follow the step-by-step instructions provided by the upgrade application. The XtremeDV-
HD4+ is shipped with the SW2
SWITCH
set at ON, therefore no action should be necessary.
In the unlikely event that something goes wrong during the upgrade process (e.g. System power
outage) it is possible to revert to the factory settings by powering down the system, temporarily setting
SW2 to the OFF position then powering up the system. Once the system has rebooted, set the SW2
back to the ON position (while the system is still powered up) and restart the
firmware upgrade process.
It should be noted that the latest driver installation program includes an automatic firmware update, if
required. Therefore, prior to installing the application and driver, ensure that SW2 is set to ON.
Fig.6