Assembly and Operation
14
© 2012 Little River Research & Design; updated July 2018
STEP 8 - Attach and position the tubing and flow outlet
Connect flow outlet to the tubing as shown below in Figure 12.
Figure 12. Insert the flow outlet into the tubing.
After the tubing is attached, align and attach the mushroom fasteners on the back of the flow
outlet to the fasteners on the inside of the box at the upstream end, as shown in Figure 13. The
outlet should snap into place.
Figure 13. Align the mushroom fasteners on the flow outlet with those on the inside of the box at the
upstream end. Snap the fasteners together to secure the outlet to the box.
Place the tubing along the inside edge of the box, starting from the attached flow outlet. The
tubing should run out of the box and into the reservoir, where it is connected to the pump (see
Figure 1). Starting from the upstream end, roll the tubing under the lip of the box until you are
near the standpipe. This will keep the tubing from interfering with demonstrations and media
behavior. See Figure 14
.
