Assembly and Operation
12
© 2012 Little River Research & Design; updated July 2018
STEP 4 - Position the reservoir
Place the reservoir beneath the box at the downstream end. The reservoir should be located as
shown in Figure 9 so that the standpipe will drain into the reservoir. Note that the support at
the downstream end of the box has an opening for the reservoir.
Figure 9. Place the reservoir beneath the support
at the downstream end.
STEP 5 - Position the pump
Attach one end of the tubing onto the arm of the pump. Place the pump, lying on its side, in the
bottom of the reservoir, keeping the wire connectors outside of the reservoir. Check that the
filter is securely attached to the pump.
Note that you may have a pump and filter that look
different than those in the photo, but the setup is the same for each.
Figure 10. Place the pump with filter in the bottom of the reservoir, lying on its side. The filter easily screws
onto the pump. The tubing is attached to the arm on the pump.
