Empire Mantis FG28BM-1, Руководство по установке

Страница: 37 / 52

31792-4-1115 Page 37
REMOTE INSTRUCTIONS
ACTIVATING THE KEYPAD LOCK
The remote control has a function for locking the keypad to pre-
vent accidental modifications to fireplace settings as the result of
buttons being pressed inadvertently or children playing with the
remote control.
To activate the keypad lock, press and hold the “O” button , the
lock symbol will appear on the screen to confirm that the
keypad is locked (Figure 55). Repeat the procedure to deactivate
the keypad lock.
MAN
Figure 55
INITIAL START-UP
Starting Up / Shutting Down the Fireplace from the Remote
Control
ATTENTION
BEFORE YOU CAN USE THE REMOTE CONTROL TO OP -
ERATE THE FIREPLACE, THE FIREPLACE MODE MUST BE
SET TO “REMOTE”. THE FIREPLACE DISPLAY PANEL WILL
SHOW A DOUBLE DASH “- -” WHEN IN REMOTE MODE.
Use the remote control power button to start up the fireplace. If the
remote is in standby (PILOT) mode, press and release the power
button. If the remote is off, press and hold the power button for two
seconds. See Figure 56.
After a start-up phase lasting about one minute, 15 seconds the
fireplace enters normal functioning mode.
To shut down the fireplace, press and release the power button on
the remote to place it in standby (PILOT) mode or hold the power
button for two seconds to turn the remote off. When the fireplace
is shut down, a post-purge procedure starts. This shuts down the
gas valve, runs exhaust for ten seconds and keeps the fan run -
ning until the fireplace has cooled to a safe temperature. The post-
purge phase lasts for several minutes depending on how long the
fireplace has been running and the flame level setting in use.
MAN
Figure 56
Starting Up / Shutting Down the Fireplace from the Display
Panel
If the remote control develops a fault or its batteries run out, you
can operate the fireplace from its display panel. See page 32 for
further information.