26670-4-0313
Page 21
Check the following items during installation prior to lighting
the multisided burner:
•
Check all carryover ports for blockage from the ceramic
media
o If there is blockage, use a small pointed tool to move the
ceramic media away from the carryover port.
•
Check air shutter for correct setting.
o NAT gas – Air shutter 1/8" (3.2 mm) minimum open
o LP gas – Air shutter full open
•
For best results when lighting the burner, have your adjustable
flame knob to the HI position, then adjust to a lower setting
after the burner has ignited.
•
When first lighting the pilot on the burner, it takes approximately
60 to 75 seconds to fully heat and energize the thermopile.
Once the thermopile is energized, turn on the gas valve and
light the burner.
AIR SHUTTER
1/8” (3.2mm) OPEN
AIR SHUTTER
FULL OPEN
BURNER INSTRUCTIONS