Empire Comfort Systems VFP30CA30BN-3, Руководство пользователя

Страница: 19 / 32

26563-4-0111 Page 19
9. Slight smoke or odor during initial operation.
a. Residues from manufacturing processes and logs curing -
Problem will stop after a few hours of operation.
10. heater produces a whistling noise when main burner is
lit.
a. Turning control knob to HI position when main burner is
cold - Turn control knob to LO position and let warm up for
a minute.
b. Air in gas line - Operate main burner until air is removed
from line. Have gas line checked by local gas company.
c. Air passageways on heater blocked - Observe minimum
installation clearances (see page 9).
d. Dirty or partially clogged main burner orifice - Clean main
burner and main burner orifice or replace main burner
orifice.
11. heater produces a clicking/ticking noise just after main
burner is lit or shut off.
a. Metal expanding while heating or contracting while cooling
- this is common with most heaters. if noise is excessive,
contact service person.
12. heater produces unwanted odor.
a. Heater burning vapors from paint, hair spray, glues, cleaners,
chemicals, new carpet, etc. - open window to ventilate
room. stop using odor causing products while heater is
operating.
b. Low fuel supply - Refill supply tank.
c. Gas leak - Locate and correct all leaks.
13. heater shuts off in use (ODS operates).
a. Not enough fresh air is available - Open window and/or door
for ventilation.
b. Low line pressure - Contact local gas company.
c. ODS/pilot is partially clogged - Clean ODS/pilot.
14. Gas odor even when control knob is in OFF position.
a. Gas leak - Locate and correct all leaks.
b. Control valve defective - Replace control valve.
15. Gas odor during combustion.
a. Foreign matter between logs and main burner - remove
foreign matter.
b. Gas leak - Locate and correct all leaks.
16. Doors open on their own.
a. casting not level.
- Loosen front leveling bolts to elevate front of casting slightly
above the rear of casting.
TROUBLEShOOTING (continued)