27825-7-1212
Page 13
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR
EXpLOSION MAY RESULT CAUSING pROpERTY DAMAGE, pERSONAL INJURY, OR
LOSS OF LIFE.
A. BEFORE LIGHTING, smell around the appliance area for
gas. Be sure to smell next to the floor because some gas
in heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch.
• Do not use any phone in your building.
• Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions. If you can not reach your gas
supplier, call the fire department.
B. Use only your hand to push in or turn the gas control
knob. Never use tools. If the knob will not push in or
turn by hand, don't try to repair it, call a qualified service
technician. Force or attempted repair may result in a fire
or explosion.
C. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect
the appliance and to replace any part of the control system
and any gas control which has been under water.
LIGHTING INSTRUCTIONS
TO TURN OFF GAS TO APPLIANCE
1. Locate On/Off gas cock and turn clockwise to
"OFF." Do not force.
1. STOp! Read the safety information above.
2. Turn gas cock counterclockwise
to "ON"
position.
3. Wait ten (10) minutes to clear out any gas. Then smell
for gas, including near the floor. If you smell gas, SToP!
Follow "B" in the safety information above on this label.
If you do not smell gas, go to the next step.
4. Turn ON electric power to the appliance.
5. Find spark and sensor probes.
6. Using the remote control, turn main flame to "oN." If the
burner does not light within 60 seconds, stop and go to
Step 5.
7. If the burner does not stay lit, stop and immediately call
a qualified service technician or gas supplier.
8. If the burner does not operate properly after several tries,
turn the gas control knob clockwise
to "OFF"
and call your service technician or gas supplier.
9. Operation of the gas valve must be controlled by using
the hand held remote control. Refer to remote instructions
for detailed operation information.
OFF
ON
OLp(36,42)Fp72 LIGHTING INSTRUCTIONS
Provided by installer.
PROBE
SPARKING
PROBE
SENSING PROBE
