Empire Comfort Systems DXL30IN91N-2, Инструкция по установке и руководство пользователя, Страница: 20 / 36

34961-2-1015 Page 20
REMOTE CONTROL OPERATION INSTRUCTIONS
Initializing the System for the First Time
1. Install the three AAA type batteries in the Transmitter battery
bay located on the base of the Transmitter (back side). See
Figure 26.
2. Power the receiver
3. With the ON/OFF rocker switch turned ON, press red button
on the module.
4. The Receiver will “beep” three times to indicate that it is
ready to synchronize with a Transmitter.
5. With the batteries already installed in the Transmitter, push
the “ON” button. The Receiver will “beep” to indicate the
Transmitter’s command is accepted and set to the particular
code of that Transmitter.
6. The system is now initialized.
Figure 26
Temperature Indication Display
With the system in the “OFF” position, press the THERMOSTAT
key and the MODE key at the same time.
Look at the LCD screen on the Transmitter to verify that a °C or
°F is visible to the right of the Room Temperature display. See
Figures 27a and 27b.
Figure 27a - Degrees Celsius
Figure 27b - Degrees Fahrenheit
Turn the Appliance ON and OFF
1. With the system OFF, press the ON/OFF key on the Trans-
mitter. The Transmitter LCD display will show some other
active Icons on the screen. At the same time the Receiver
will activate the appliance.
2. A “beep” from the Receiver will confirm reception of the com -
mand.
3. TURN OFF THE APPLIANCE
4. With the system ON , press the ON/OFF Key on the Trans-
mitter. The Transmitter LCD display will show the room
temperature. See Figure 28. At the same time the Receiver
will turn off the appliance.
5. A “beep” from the Receiver confirms reception of the com -
mand.
Figure 40