28653-2-0811
Page 41
Before you begin: If you are installing logs into the DVX36 or DVX42
model then this fireplace is supplied with a set of 13 ceramic fiber
logs. Do not handle these logs with your bare hands. Always wear
gloves to prevent skin irritation from ceramic fibers. After handling
logs, wash your hands gently with soap and water to remove any
traces of fiber.
The positioning of logs is critical to safe and clean operation of
this fireplace. Sooting and other problems may result if the logs
are not properly and firmly positioned in the fireplace. Please refer
to
Figures 66 through 69
and corresponding WARNING, when
completing the following log placement steps.
1. Remove front. See Page 67.
2. Remove glass door from firebox.
3. Remove logs from bun.
4. Place Rear Bottom Log (A) on the rear part of the burner over
the pilot.
5. Place Rear Top Log (B) on log shelf on burner ensuring pins
go into holes on bottom of log.
6. Place Bottom Left Log (C) on far left pin of burner. The "lip" of
the log will hang off the side of the burner.
7. Place Bottom Left Center Log (D) on second and third pins
from left side of the burner.
8. Place Bottom Right Center Log (E) on fourth and fifth pins from
the left side of the burner.
LOG PLACEMENT (13 LOG SET)