26408-0-1009
Page 41
Attention: Do not use
Figure 63
or
Figure 64
to order logs.
Refer to parts view on page 65 and parts list on pages 66 and
67 to order logs and/or ember material for your appropriate
fireplace model.
Before you begin: This fireplace is supplied with a set of four
ceramic fiber logs. Do not handle these logs with your bare
hands. Always wear gloves to prevent skin irritation from
ceramic fibers. After handling logs, wash your hands gently with
soap and water to remove any traces of fiber.
The positioning of logs is critical to safe and clean operation of
this fireplace. Sooting and other problems may result if the logs
are not properly and firmly positioned in the fireplace. Please
refer to
Figure 62, Figure 63, and Figure 64
and corresponding
WARNING, when completing the following log placement
steps.
1. Remove Decorative Doors (where applicable) by opening
and lifting straight up.
2. Remove Decorative Front. See page 64.
3. Release two glass frame spring clamps at bottom of
firebox
4. Place rear (#1) log onto two (2) pins on rear log support.
5. Place left, front (#2) log onto two (2) left, front pins on
burner pan.
6. Place right, front (#3) log onto two (2) right, front pins on
burner pan.
7. Place Branch (#4) onto one (1) pin on rear log
8. Place decorative rock in front of grates and sides of main
burner.
9. After all logs are properly positioned, place small "dime"
size pieces of Rockwool lightly across the front round
"blueflame" ports. Place the ember material (Rockwool
pieces) side by side. Do not stack more than one layer of
embers across the burner ports.
See Figure 62.
10. Replace glass door onto firebox.
11. Secure the two glass frame spring clamps at bottom of
firebox.
12. Replace Decorative Front. See Page 64.
13. Replace Decorative Doors (where applicable) by aligning
hinges over posts.
Figure 63
Figure 62
Figure 64
ATTENTION: Do not place decorative rock on logs or on
burner. The decorative rock should only be placed on the
fireplace floor.
WARNING: Failure to position the parts in accordance
with this diagram or failure to use only parts specifically
approved with this appliance may result in property damage
or personal injury.
LoG PLACEMEnT (4 LoG SET)
#4 - TOP BRANCH
#1 - REAR LOG
#3 - FRONT
RIGHT LOG
#2 - FRONT
LEFT LOG
EMBER
PLACEMENT
REAR LOG
LOCATOR TABS
FRONT LOG
LOCATOR PINS